Preview: Smok SCAR-P5 – 18650, a pair of cartridges and IP67June 19, 2020
The day closes with the promised flagship Smok vape mod. There are not so many differences from the previous SCAR-P3 novelty, therefore I will not particularly get angry and will focus only on them. Today we will the Smok SCAR-P5 kit.
Dimensions: 117.6 x 35.8 x 28 mm
Case material: zinc alloy + plastic
Power: 1 x 18650
Chipset: IQ-80 chip
cartridge capacity: 5ml
evaporator Resistance: 0.16 / 0.4Ω
Output Power: 5 – 80W
Voltage range: 0.5 – 4.0V
Operating mode: VW
Supported resistance: 0.15 – 2.5Ω
Corporate design – the previous two newcomers from Smok are thus embellished. Nice, but not very original. On the other hand, it is extremely difficult to offer the market something really new right now – it is oversaturated.
Dimensions compared with the younger brother, for obvious reasons, slightly increased. IP67 protection – against dust, water, etc. – there is also here.
There are also two, two, and evaporators cartridges – each for its own. The serviced base is available old, sold separately. Airflow adjustment is not provided. Refueling top – slide cover – but for some reason, the capacity is less by 0.5ml)
Perhaps the most striking difference between this instance is the “power manner.” So, 18650 vape batteries are used as a battery. Access in the compartment for it from the bottom – there is a hinged lid. Moreover, the latch button is located on the side of the mod. It is interesting how long this construct will last.
Other products we would like to recommend: